Black car on the left is a sample only , not included with kit.

Comes with block, 4 Pinecar brand wheels, 4 axles and instructions. Axle slot location is the same as BSA.

$4. 50 ea.

Purple car on the left is a sample only , not included with kit.

Same as basic pinewood derby kit but features pre-drilled weight holes and a weight set, approximatly 2 ounces sold with the kit. The weight holes are located in the back and are deep enough to accommodate 3 ounces of our weights. Axle slot location is the same as BSA

$7. 50 ea.

Orange Stock car on the left is a sample only, not included with kit.

This is a pre-cut pinewood derby car kit that's similar to a Stock car. It has wheel wells and only requires a little sanding to get it ready for paint. The kit comes with a pre-cut block, 4 Pinecar brand wheels, 4 axles and building instructions. The car also features 4 weight holes located inside the wheel wells designed to use with our weights. Car width is 2-9/16", less than the 2-3/4" max. for most races.

$14. 00 ea.

Blue truck on left side is a sample only, not included with kit.

This is a pre-cut pinewood derby kit that's similar to a Stock truck. It has wheel wells and only requires a little sanding to get it ready for paint. The kit comes with a rough cut block, 4 Pinecar brand wheels, 4 axles and building instructions. The truck also features 4 weight holes located inside the wheel wells designed to use with Mills Crafts weights.Car width is 2-9/16", less than the 2-3/4" max. for most races.

$14. 00 ea.

Finished car on the left is a sample only, not included with kit.

This is a pre-cut wedge type pinewood derby car with pre-drilled weight holes. This kit includes a weight set that is not lead and easy to get the car up to racing weight. The wedge block only requires a little sanding to get it ready for paint. The kit comes with a pre-cut wedge block, approximately 3 ounces of weight, 4 Pinecar brand wheels, 4 axles and building instructions.

$8.50 ea.

Red finished Mustang is a sample only , not included with kit.

This is a pre-cut Mustang pinewood derby car with pre-drilled weight holes. This rough cut unfinished kit includes a weight set that is not lead and easy to get the car up to racing weight. The Mustang block only requires a little sanding to get it ready for paint. The kit comes with a pre-cut Mustang block, approximately 1 ounce of weight, 4 Pinecar brand wheels, 4 axles and building instructions. Car width is 2-9/16", less than the 2-3/4" max. for most races.

$15.00 ea.